Electrically conductive, when electronic equipment is connected, there is a current inside, so after a period of use, there will be heat transfer on the surface, so heat is also a very normal phenomenon, but we must prevent overheating. This will damage the din 41612 type g connectors.

1. When a fault is found, disassemble the power cord din 41612 type g connectors and unscrew the conductive column in the electric water heater socket, grinding with zero emery cloth or grinding paste until bright. Reduce contact resistance by removing wire, connection screws, tongue and oxide layer in conductive column in socket on electric water heater at connection point of power cord to din 41612 type g connectors

2. Apply a small amount of conductive paste to the power cable connector and the electrical water heater socket conductor post.

3.din 41612 type g connectors tongue and wiring screws should be replaced immediately if they are badly burned.

4. The socket and conductive column on the electric water heater should be removed immediately if the damage is severe, and the socket and conductive column of the same specification should be replaced. When installing the electric water heater socket, a power knife switch should be added.

din 41612 type g connectors https://www.kujunconnector.com/TYPE-G-Connectors